Must Know Starter Too Far Away From Flywheel References
Starter Too Far Away From Flywheel. Remove the torque converter/flywheel cover from the bottom of the bell housing. The starter will spin, but you can hear it grinding against the ring gear, just not far enough in to engage it.
After taking it to a dealer to have it looked at, we determined that the starter gear is too far away from the flywheel, even with no shimes. Starter spins but doesn't engage. If you turn the vehicle’s ignition switch on and it produces a whining noise.
So, To Know If Your Vehicle’s Starter Or Flywheel Is Bad, Take Time To Observe Your Car When You Start It.
The last starter ate up my ring gear, so i replaced both three weeks ago. It is very possible this is the cause of your. After taking it to a dealer to have it looked at, we determined that the starter gear is too far away from the flywheel, even with no shimes.
About Press Copyright Contact Us Creators Advertise Developers Terms Privacy Policy & Safety How Youtube Works Test New Features Press Copyright Contact Us Creators.
I've tried loosening the mounting bolts, sliding starter inward as far as. Starter to flywheel clearance you should have 0.020” clearance between the valley of the teeth of the flywheel and the tip of the tooth of the starter drive gear. I believe the flywheel is a 158 tooth while the original off the 351w was a 164 tooth.
The Engagement Between A Starter And A Flexplate Or Flywheel Is Critical If You Want Your Engine To Start Without Any Issues Each Time You Hit The Ignition Switch.
Using the flywheel turning tool, turn the flywheel and examine the flywheel teeth. If you turn the vehicle’s ignition switch on and it produces a whining noise. If you look close at the picture you have posted it looks like the two teeth on the flywheel ring gear on the right are worn down.
The Teeth On The Flywheel Still Look.
Sometimes you just have to try another nose, right now a friend's boss's 79 4x4 has problem of teeth only engaging halfway and there is no way to make the starter gear be any closer to the flexplate teeth because there are no shims to remove, his only option really is to. Original gm motor and the starter took out the flex plate. Starter spins but doesn't engage.
I Have A 79 Camaro With A 383 Stroker When I Baught The Car It Had A Delco Starter That Bearaly Turned It Over So I Thought Ok I Will Just Put A High Torque Mini Starter On It Well To.
You hear it spinning like normally it should, but it comes with a grinding sound like sprockets not engaging correctly:. Remove the torque converter/flywheel cover from the bottom of the bell housing. The starter will spin, but you can hear it grinding against the ring gear, just not far enough in to engage it.